Designed for maximum impenetrability to automatically guide personnel in and out of secure areas.

Turnstile Operation

Type ELO: Exit or entry rotation is allowed by signal from Card Reader, Biometric Reader, Remote Control, Push-button, Control panel, etc. Turnstile is fitted with STD 100 locking arrangement.

Type MO: Rotation in either both directions or one predetermined direction freely on hand-push. Turnstile is fitted with WUNL arrangement, and is not lockable as standard but has lockable option.

Rotation in either both directions or one predetermined direction freely on hand-push. Turnstile is fitted with WUNL arrangement, and is not lockable as standard but has lockable option.

 

Type BIO: Exit or entry rotation is allowed by signal from a single Biometric/Fingerprint Reader situated in the middle of the Turnstile thus eliminating the need for two readers.

 

Turnstile Lock Mechanism

The bi-directional, shock absorbent turnstile lock mechanism (STD 100) is of a simple robust design whereby lock and release arrangement is operated by linear motors. Emergency release mechanical override (fitted with a security lock to avoid misuse) is provided for free gate rotation or positive lock when desired, in case of electrical power or control system failure. A spring-loaded device prevents the gate from further rotation after the user stops pushing on the gate arm and positions the rotor into its “locked position”.
Automatic control prevents the gate from turning in the forbidden direction once rotor has moved through 45º from rest.

An “automatic lock-up” locking arrangement is a standard turnstile feature. Should the mains power fail or be switched off, the turnstile becomes locked in both directions. It can then be unlocked in the desired direction mechanically with a key. An “automatic unlock” locking arrangement is offered as an option.

 

Design Features

Main Frame: Sturdy, fully welded construction manufactured from low carbon steel heavy channels, flats and square hollow sections. The hollow sections provide ideal conducting power and control cables.

Four Arm Rotating Gate: Square hollow centre column with end shafts located in sealed bearing blocks with welded on 32 diameter tube gate arms curved to U-shaped loops.

Barrier in forbidden Direction: 38 diameter tubing fitted with protective end cups on double turnstile; 32 diameter tubing curved to U-shaped loop on single turnstile.

 

Installation

All units are completely factory assembled and tested, minimizing installation time.

 

BUILDING REQUIREMENTS

Firm levelled concrete screed plinth with a minimum strength of 20Mpa, suitable to accept drill-in M12 x 75mm long anchor bolts.

Model HTG: Plinth 1600 x 1000; 8-off M12 Anchor Bolts drilled in on installation.
Model DHTG: Plinth 2400 x 1000; 12-off M12 Anchor Bolts drilled in on installation.

 

Electrical Power Requirements

220V single phase 50Hz; power consumption: 2,3 amps at 24 volts Dc per lock arrangement.3 core (220V AC, 15A) power cable. (7 core x 0,5mm min cable if push-button control is required) on turnstile rotor centreline – on top – for connecting into lock arrangement and Standard Control Logic respectively. Standard Control Logic is offered to interface turnstile lock arrangement with controls supplied by others (card-reader, push-button, tokens, etc.).