FS Fire Shutters
Roché fire shutters have been tested and approved in accordance with BS 476: Part 22 and are documented in report references WARRES No. 61083 and WF No. 182970. Warrington Fire WF Assessment Report 181246 Issue 2 provides for modifications for fire shutters to be capable of satisfying the integrity performance criterion for fire resistance for a period of 120 or 240 minutes.
| Technical Downloads |
| 2001 FS240 Overview (PDF) |
Applications
Commercial sites where fire protection is required, up to 50M².
Curtain Slat
Single Skin 76mm Curved Steel
Standard galvanised finish
N.B. The FS fire shutter profile can be powder coated any colour as required.
Profile Height 86.6mm
Weight per m2 10kg
Maximum Width 12,000mm
Maximum Surface 25m2 (single phase), 50m2 (3 phase)
Housing
Manufactured from 1.2mm galvanised steel sheet.
End caps are fabricated from 5mm steel.
Standard galvanised finish. Other colours available on request.
Enclosure Height Guide Length
(mm) (up to mm)
305 <2600
350 >2600
N.B. The above enclosure sizes are based on standard tube motor operation.
Guide Channels / Bottom Slat
Galvanised steel sections.
Guide channel depth will vary dependent on application from 50mm to 100mm.
Standard galvanised finish. Other colours available on request.
N.B. The guide channels are bolted to fixing angles to suit the application.
Operation
Electric: Single phase tubular motor with push button control or key switch as standard. Interface panel for connection into the fire alarm. The shutter descends when the fire alarm signal is received.
N.B. Manual operation via a fuse link is possible, but not recommended.
Options:
Audio-visual display & timer delay.
Battery back to ensure effective operation in the event of power failure.
